HT, Filters, Misc Parts and more FS


Ken, W8EK
 

Kenwood Dual Band HT, Crystal Filters,
Mobile mount, Misc Parts, and more For Sale

.

Kenwood TH-G71 Dual Band HT:

The Kenwood TH-G71A is a dual bander with all
the right features.

Besides being easy to use, the TH-G71A also
boasts power up to 6 watts (VHF) or 5.5 (UHF)
with external power. You also get .5 W or .05 W.
200 memory channels, with six alphanumeric
characters. Multiple scan functions are available.

It includes the PB-39 high powered battery,
BC-17 AC Charger, Belt Clip and SMA flexible
antenna. Only 2.3 x 4.5 x 1.3 inches.

Features:
200 Alpha Memories
Key Illumination
Multi Scanning Modes
Built-in encode/decode
Easy to use menu
3 RF Out Levels

This one looks like new, and works the same.
In includes a PB-39 H, high capacity 1450 Mahr
battery plus the regular one. Both hold a
charge and work well.

This one also includes the BP-19 desk charger,
and the wall wart charger.

With paper work for $145.

.

Kenwood Crystal Filters
All work as they should and are solder in type.
They look fine also, as if that matters
for a filter inside the rig.

These filters are used in rigs such as the
TS-120, TS-130, TS-430, TS-440, TS-520,
TS-530, TS-820, TS-830, and others.

Kenwood YK-88 SN, 1800 Hz SSB Filter
This is the narrow SSB filter, that can
also be used for wide CW. $79

Kenwood YK-88 C, 500 Hz CW Filter $79

Kenwood YG-455 C, 500 Hz CW Filter
This is used in the 455 KHz IF, and will work
in a wide variety of rigs. $125

.

Kenwood MB-430 Mobile Bracket:

The Kenwood MB-430 is the mobile bracket
that is used to mount the Kenwood TS-430,
TS-440, TS-450, R-5000 and maybe others.

This one is in nice shape and includes
the four screws (and washers) for attaching
it to the rig.

These are no longer made and are somewhat
rare.

Buy this one for $40

.

Linear Amp Switching Cables for Kenwood Rigs For Sale:
-
This cable goes from a Kenwood transceiver to a linear
amplifier to switch the amp from transmit to receive.
-
One end has a DIN connector, as is used with most Kenwood
rigs. The other end has an RCA phono plug, as used by most
linear amplifiers.
-
Before using this cable, please check the switching
capabilities of your transceiver, and the requirements
of your amplifier.
-
Cable for switching the T/R relay Only $15.
-
Cable with ALC control, in addition to T/R switching. $20

.

10 meter Crystals for Kenwood HF Rigs:

These crystals work in the Kenwood TS-820
for sure (they have been tested in a TS-820),
and probably will also work in most of the
other Kenwood "Hybrid" rigs. Please check
your manual.

Set of three crystals
These crystals will restore all three 10 meter
segments. They are used after someone
"converted" your rig to 11 meters, and you
would like it back on 10 meters.
They simply plug in, so no difficult surgery is
needed.

$35 plus shipping for the set of three.

.

I have parts for a Kenwood TS-440 available.

Hopefully we can keep a couple units working
and looking nice using these parts.

The rear part of the bottom cover is presently
available.
It looks very nice, and might improve the
looks of your rig.

The small little silver rectangular buttons
are still available.

The "IF" internal PC board is available
as well.

Most small PC boards, such as selectivity switch,
mic jack, front panel push buttons, etc. are
available.

A few knobs are available.

The automatic antenna tuner is NOT available.

Please let me know what you need.

.

Antenna adapter for Kenwood TH-21/31/41 HTs
Adapts the antenna connector found on these HTs to a
standard PL-259 connector. $8

.

I also have many other accessories available such as many
different types of microphones, HTs, VHF and UHF rigs, HF
and VHF/UHF antennas, connectors, miscellaneous accessories,
etc.
Just too many to list here. Please e-mail your requests.

.
Prices do not include shipping from Florida.

Thanks.

73,

Ken, W8EK

Ken Simpson
E-mail to W8EK at FLHam.net or W8EK at arrl.net
Voice Phone (352) 732-8400




.

Join main@Kenwood-radios.groups.io to automatically receive all group messages.